| Content | BZERK: Gear Lever Tip. +15mm Extension / +10mm Width – To Fit The 43043/43046/43047 Type Levers as shown in the images, will not fit the 43039 ‘wrap around’ new type lever.
This billet aluminium, anodised in blue, replacement gear lever tip is a must for the ‘larger footed’ rider. The BZERK modified tip will not only extend the overall length of your OEM TM Racing gear lever by 15mm, but also increase the width of the ‘Knurled’ part of the lever by 10mm to give you a larger surface area for boot contact. The ‘knurled’ part of each tip is replaceable (available soon) and is fitted to the pivot section of the tip assembly by an Allen bolt. Each tip comes with a fitting kit.
Fits TM Racing gear levers: 43047/43048 (all levers from 2012 with the ‘billet’ tip – as shown side-by-side in the image)
BZERK:GLT.+15/+10 | TM Racing Billet Machined Clutch Cover for the 450Fi 4-stroke engines.
This billet machined finned cover gives increased strength over the stock cast casing and allows for greater heat dissipation and with the internal oil channel increases the centre lubrication on the clutch plate system. This component is machined from a single aluminium block on a CNC machine in a process that takes over 10 hours to complete.
TM Part No' - F30967 - 450cc
| SAM Racing Parts water pump kit. This CNC' aluminium water pump impeller / spacer kit - designed for the 250cc / 300cc 2019> models - will increase the coolant flow around the engine, helping to reduce engine temperatures and ensure adequate cooling in extreme conditions where overheating may occur.
This kit compromises of: larger impeller - spacer to increase the pump space - fitting o-ring - required extended length bolts.
Part No' SAM-WPK250-19-396 | TM Racing genuine Start Device for KYB 48mm and Marzocchi 50mm forks.
Lift Control device for forks fitted to TM Racing machines, CNC machined from billet aluminium and colour finished.
Comes with fork leg engagement ring, fork guard spring-loaded lock/return button, a set of fork guard 'strengthening' plates and all fittings.
TM Part No': 72111 | JEMX Fuel Cap for TM Racing 4-Stroke Machines from 2015>
A billet machined aluminium fuel cap, with a larger 'finger' surface area, designed to facilitate easier removal and refitting.
Comes complete with o'ring seal. For all 2015> TM Racing 4-Stroke machines with the 'under-seat' fuel tank arrangement.
Available in red, featuring the JemX logo. | CMT / Virus - TM Racing Carbon Fibre 250cc / 300cc 2-Stroke Pipe Guard : 2015>2018
Carbon Fibre expansion chamber guards for TM Racing 2-stroke models.
250cc / 300cc: 2015>2018
|
