Content | SAM Racing Parts: Brembo Clutch & Front Brake Reservoir Caps.
A set (pair) of billet machined aluminium reservoir caps, finished in blue.
Fits all Brembo Clutch Master cylinders and Brembo Front Brake Master Cylinder equipped machines.
Part Number: SAM-MSTCYLCAPS.2BLU-410 | TM Racing Carbon Fibre Airboot Insert.
The TM Racing Carbon Fibre Airboot Insert is designed to add rigidity to the flexible airboot between the airbox and the carburettor.
Shaped to the exact contours of the airboot itself, this carbon insert increases rigidity to ensure that when maximum engine loading is being applied, alongside higher temperatures that may 'soften' the rubber, the airboot does not deform under vacuum and actually reduce the volume of air available to the carburettor. The carbon insert will therefore allow the engine to produce greater performance under the largest loads, maximising available power.
To fit the carbon insert the airbox / airboot assembly will have to be removed from the sub-frame and disassembled. Fitting the carbon insert into the airboot will require patience and care due to the fine and intricate construction of the carbon fibre insert. Importantly, the airboot will have to be re-sealed to the air-filter mounting plate, therefore you must ensure you clean all mating faces and remove any existing sealant before the refitting and re-assembly procedure can begin.
Please note that after fitting the carbon insert that carburettor removal / refitting will be more complex as the flexibility of the airboot - that previously aided removal / refitting - will be reduced. Do not 'force' fit the carburettor as you may damage the carbon insert. It is advised that to remove / refit the carburettor the sub-frame should be loosened and lifted slightly to give greater clearance.
Fits 125cc / 144cc / 250cc / 300cc carburettor models from 2015>2021 ( all models with the 66022.15 airboot )
TM Part No' 55104
| Billet Exhaust Anti-Vibration Mount for TM Racing Machines - Replaces OEM 'cast' part, No 21094 that was previously billet also.
Laser-cut from billet aluminium, to increase durability and increase strength over the now stock, cast alloy, anti-vibration mount - TM Part No' 21094.
A small but effective upgrade to a vital component that will still 'bend' / 'give' in an extreme pipe impact. Each mount comes ready to fit with a damping rubber and centre top-hat.
Sold individually.
Part No' TMUK-REP:21094
| Footrest Lowering Kit: 35mm drop
Fits the 2013> TM Racing 85 mx Junior machine (its intended purpose) but also fits all adult sized machines from 2008>2021 with the '00620' footrest mountings.
Kit consists of a left and right hand mountings, new rear brake pedal adjustment bolt (85cc), new return spring and a new gear lever with the correct bend position. | SAM Racing Parts Caliper Holder, fits all 2015> Adult / full sized machines.
This CNC machined caliper holder is designed to hold the caliper in place, on its location perch, during rear wheel removal and re-fitting. An especially useful addition on endurance type events where quick wheel changes are paramount and time wasted trying to re-locate the caliper could be costly. This part replaces the removal axle block. Used by the TM Racing Factory Teams.
Supplied with fitting bolt.
Part No' SAM-CALHOL-15>-393 | TM Racing genuine Start Device for the Junior 2013> Models with Formula Forks
CNC machined from billet aluminium and finished in gunmetal.
Comes with all fittings and attachments, including a new rubber cap for the fork guard button
TM Part No': 72163 |